[qwagv]

Water fills then stops! Lid switch replaced,same result

[denman]

Here is a link with parts and a wiring diagram. May help.
Maytag LAT9205AAE

A timing chart would help, take a look in the control console, it may be there or on the back of the unit. Then at least you will know what contacts are closed when, in the timer. Manually turn the timer and try to get it to drain

Next I would get out a meter and check the water level switch to ensure that it's contacts 7 to 16 are actually closed. I would check it using resistance readings so unplug the unit.

Did you replace the lid switch assembly or just a switch?
I would also check this with a meter, it is not unheard of to get a defective part directly from the factory. Also sometimes there is enough wiggle room on the switch mount to cause a problem.

[qwagv]

Thanks for the HELP !! I found it to be a bad timer!