[pekbagger]

Have part in hand, but no way of knowing how to replace it. Can anyone tell me step by step how to replace the spin belt. Desperately need to wash clothes!

[PS Staff - Sheila]

Remove the two screws in the front panel.

Pull the bottom of the panel out until the hold down clips on the top edge of the panel disengage.

Reach in through the front of the motor mount and move the idler lever to the left to release the tension on the belt if it is still on.

Do not over stretch the springs.

Disconnect the wiring harness from the motor switch.

Remove the four screws holding the motor and mounting bracket to the washer base.

Remove the three screws holding the pump assembly to the motor.

Install the belt and pump back on the motor.

The belt has to encircle the back leg of the pump.

Reinstall the three screws in the pump.

Do not over tighten.

Reinstall the motor and pump assembly into the washer.