[magus]

During fill, I have a leak that seems to start at the top of the washer transmission, and runs down the transmission cap and over the side. This occurs during the fill process, starting 40-60 seconds after water pours into the 8 drain screens at the bottom of the inner tub. At this point, I am not sure where the leak is happening. I have disassembled the washer from the top down, but now I am stuck at removing the inner basket from the top of the transmission. But even if I get the inner tub out, I'm not sure what I am looking for.

Does this leak sound familiar to anyone? If so, I'd appreciate some clues as to how I can get to the problem. Thanks!

[PS Staff - Sheila]

It sounds like the bearing and seals will have to be replaced.

The link I have provided should assist you with the dismantling of your washer.

Here is a link to your washer model SAV2555AWW.

[magus]

Thank you for replying to this Sheila.

I agree with your diagnosis of a bearing/seal problem.

Do I need the triple lip/seal bearing kit (PS993570)? If so, do I also have to order a seal nut (PS61433)? My serial number begins with a "10", so I am assuming it's a series 10.

I had already found the link you refer to, and it was very helpful in taking apart the washer. Unfortunately, the link does not describe how to get at the bearing.

Perhaps you could help me do this. I have already removed the agitator, and the bolts at the bottom of the basket.

There is a plastic fitting at the bottom (around the base of the transmission shaft) with 8 vertical splines around its circumference. I tried to turn it, but it seems frozen. I did want to force it because I wasn't sure if it unscrews.

Can you please tell me how to take this off, and how to take out the main bearing and seals? I should be able to figure out how to put it back together.

Thanks for your time!

Nils.

[PS Staff - Sheila]

Nils,

This is a major job.

The nut does come with the triple lip/seal kit.

There is a special wrench to remove the seal nut but you may be able to do it without the wrench. It is removed in a counterclockwise direction.

You are going to have to disconnect the drain hose from the bottom of the tub.

Remove the bolt holding the motor and place on the base.

Remove the belt from the transmission pulley.

Remove the pressure hose from the pressure bulb on the outer tub.

Lift the outer tub and transmission assembly out of the washer cabinet.

Turn the outer tub and transmission assembly upside-down on a protective padding.

Remove the screws holding leg support to outer tub.

Separate the transmission assembly from outer tub.

Now you are ready to remove the seal.

This take a special tool.

You may be able to find a puller/installer at a rental shop that will work.

Then it is a matter of reassembly.

[markie1]

Sounds to me that the mounting stem and boot seal is faulty. You will need to dis assemble from inside the tub to get to the piece that needs to be changed. It just so happens that I am having the same problem but I can't find what tool is needed to remover the inner tub clamping nut. My water starts during the wash cycle. If your washer is flont load I don't have the answer. If it is top start by removing the agitator.

HOw's that?