[sexydiablo519]

I have a Kenmore front loader that has had a small leak during spin cycle, then it started to leave little grease/oil circles on my clothes(from the drain holes), It also made a load noise during spin cycle like a jet and also made banging noises. Now it starts to spin and stops like it is binding on something. The model#417.42042100 seriel#xc15008047

[PS Volunteer - Appguy]

You probably have bad bearings/seals that support the basket. Go to www. applianceaid.com for directions.

[sexydiablo519]

thanks for the link. After doing the research it looks like it will be better to go buy another washer. Looks like it would be about 400 in parts and I could get a scratch/dent one for 500. Thanks again

[PS Volunteer - Appguy]

Good idea, you might want to look at the new Whirlpool Cabrio washer, seems good and not a front loader but probably just as good, or go for the new Whirlpool direct drive washers.

[sexydiablo519]

Do you know if the bearing can be replaced without replacing the shell?

[PS Volunteer - Appguy]

For all kinds of info on bearing replacement go to Appliance Blog Forums - Powered by vBulletin, you can save lots of money,but very time consuming and may be futile if too much damage.