[SMVH]

Here's what's happening:
3 Wash/Rinse Settings: COLD/COLD, HOT/COLD, WARM COLD

When selecting:
WARM, the washer does fill with warm, a combo of hot and cold.
HOT, the washer does fill with just hot.
COLD, the washer fills with ONLY hot.

I removed the back of the Control panel and voltage is fine. Intake tubes are proplery set. Odd that I do get the correct cold water mixed with the WARM setting and HOT is hot. Only the COLD selection is messed up...comes out HOT.

Any ideas?

[jkmvenice]

Start with the control switch.

Then the water valve-pretty cheap part, maybe $15. Make sure you wire it up correctly.

Unplug machine before you attempt the repair

[SMVH]

Problem is, I didn't see a control switch. It looks like the water inlet valve is hooked right up to the Control Panel, priced at about 100.

http://www.partselect.com/ModelFrame...E&Type=&Mark=1

Guess I should start with the valve?

[SMVH]

Valve looks good-clean. As I said, I get cold, no problem, when warm is selected. Additionally, if i play with the temp. control dial, I can find a spot that COLD does come out. Looks like it is the Temp. Control Switch. Now I just need to locate it. I am thinking that it is part of the Control Panel/Circuit Board, at $100. Shown on this diagram.

GE WBSE3120B1WW Parts List

I also removed the Back Panel and Circuit Board. The Switch pokes right out of it through the front, where the dial attaches.

Am I missing it?

[bettyboop]

It could be the board, as I didn't see a separate water temp switch, I allways buy washers with analog switches, boards are prone to fail.