[rozy]

Can anyone tell me what could be wrong..I have a Gibson Front end loader that works great! Except I have to stand there and push the door in for it to run.
If I let go of the door it stops running. Push it back in and it will run for a few seconds then stop again. It continues with the cycle where it left off as long as I stand there and keep pushing on the door. I tried replacing the door latch and it still does the same. The lock light is on continuously through out this. Tonight, I did try putting a small piece of duct tape on the latch and it did run through a complete cycle. Any help would be appreciated. Thank You.

[PS Staff - Sheila]

It sounds like the door switch assembly is what is causing your problem.

Take the switch out and check it.

Here is a link to your washer model GWT445RGS1.

Here is your switch assembly.

[rozy]

Thank you so much! I will give it a try and let you know what happens.

[rozy]

That was the problem! Replaced the part that you said it was and the washer works better than it did before. Thank You so much!