[tony58]

lights in freezer not working, bulbs are good 3 in all. end cap on ice bucket broke how do i replace please help..

[PS Staff - Sheila]

Check the door light switch.

For the end cap you will have to take the ice bucket apart to replace it.

Here is a link to your fridge model msd2651heb.

[tony58]

thanks i think i have the problem fix, but do i plug in black first, red 2nd purple 3rd. does it matter if the lights stays on? IT'S A 3 PRONG SWITCH

[tony58]

Also I Have A Second Frigidaire Frt22prc I Have A Lot Of Water Inside The Refridrator, The Seal Look O.k. But The Bottom Door Doesn't Shut Tight, I Tried To Adjust The Level Wheels But That Didn't Work.

This Is In The Basement In A Very Tight Spot Only Place It Could Fit Was Landury Room Area, No Problem In The Past Stays Cold 7-10 Yrs. Old.

I Even Try The Trick About Putting Vaseline Around The Gasket, How Do I Check Out The Door Hinges Or See If It's Level,

[PS Staff - Sheila]

The answer to the first question is the light can not stay on or it will make the freezer warm.

You will have to look at the wiring diagram for the wiring.

For the second fridge the drain is likely plugged if the water is under the crispers.

There is a drain cup in the center of the fridge close to the roof of the fridge section.

Remove the cup and clean and then run a piece of flexible wire down the drain tube.

[tony58]

i order new light switch because when the light stays on the front water and ice dispener don't work, how or where can i check wiring, the 2nd fridge door still doesen't close tight that why i think it's sweating water. but will check drain cup.

[PS Staff - Sheila]

You will need a meter to check the wiring.

You can check the wire on the switch.