[bk748]

My kenmore ice maker does not dump ice; though it does make ice. I had melted the ice in the mold and taken the melted water out; then turn it back on. I can see there is new ice in the mold; but just not being dumpped to the bin? Does any body has any suggestions?

Thanks,
Charlie

[ghunter]

Model # starting with 106 are whirlpool mfg. for kenmore.these icemaker have a internal sensor to know when ice is frozen.If the icemaker cover faces forward.remove it.you will see a plastic gear .at about 5 oclock below gear is two small test holes labeled H and T I believe.If you make a small jumper wire to go into these two holes it will jump out the sensor and icemaker will start cycle.leave in untill ice ejects.with the jumper in it will not fill with water so dont be alarmed, but will verify you need to replace sensor[bimetal]

[bk748]

ghunter:
i will try it when back home. thanks for helping.
C

[bk748]

Ghunter:
Only see 1 hole at 5 o'clock. Is the other hole on the other side? Or where?
Thanks,
C

[ghunter]

not the tiny hole at bottom of "t"......the two holes[raised posts] above the "T "