[RobertE0903]

I have 2 problems. 1) the bottom door has 2 SLIDE, DRAWER (KIT, SLIDE DRAWER) and the right side slides out further that the left and because of that action the RACK (36) SHAFT which connects the 2 USE MAC (KIT, DRAWER GEAR) the SHAFT comes out of the left DRAWER GEAR

2) That Action broke the left GEAR. I have ordered a new GEAR today.

I need information on how to replace the gear and information on how to adjust the SLIDE, DRAWER (KIT, SLIDE DRAWER).

Thanks Bob

[PS Staff - Sheila]

Drawer Assembly

1. Open the drawer to the fully open position.

2. Remove the upper basket.

3. Remove the screws,one is each rail marked on the side of the rail.

4. Lift the front of the drawer up and out to remove the drawer.

Drawer Rails

1. Remove the screws inside the plastic rail retainer.

2. Remove the rails from the retainer by depressing the plastic tabs on the back side of the retainer.

3. Slide the rails off the retainer.

Rack and Pinion Gear

1. Remove the drawer assembly.

2. Extend the drawer rail to the fully opened position,remove the rails from the retainer by depressing the plastic tabs on the back side of the retainer.

3. Slide the rails,rack and pinion gear off of the retainer.

4. Reverse the procedure to reassemble.

NOTE: When reinstalling the rails,rack and the pinion gear after latching the rails in place,slide the rails,the rack and the pinion to the fully closed position and then pull out to synchronize the rack and pinion gears.

[RobertE0903]

I got the new pinion gear installed BUT never saw any screws. Maybe that is why I have problems keeping the sync bar in the pinion gears. Should I have screws on my Model Number: ABB2527DEQ? Is so where?

Thanks Bob

[PS Staff - Sheila]

Here is a link to your fridge model ABB2527DEQ.

This should show you the screws.