[ret5002]

After doing a 3 hr clean cycle my range started beeping and showing an f2 code and will not unlock .... help.....

[PS Staff - Sheila]

The F2 code stand for the oven temperature being to hot.

This is caused by a failed sensor or a welded relay on the relay board.

If the door will open now remove the sensor and check the resistance of the sensor.

It should be 1100 ohm at room temperature.

The resistance goes up as the temperature goes up.

If the resistance is good check the relay boards.

Here is a link to your oven model svd48600p.