[dpiett1597]

Hello

Must replace the INF 240P-871 Burner Switches ( front & rear )

Existing INF Switch is held in place with pressure nut on D shaft
to control panel. Question: The available replacement INF switch
is held in place with "screws " will this work on my unit ?

There ate two holes ( north & south ) on the control panel above &
below the D shaft where two small tabs on the swith fit to lock
INF switch in position. Are these holes now used for screw mounting.?

Please advise and PN# to order.

Thanks


Dan Piett

[PS Staff - Sheila]

If your switch is mounted with a nut it is best to stick with the proper mounting.

Here is a link to your range model S105.

Here is the switch for your range. The part number is PS118518.