[ArthurR6780]

After a Cleaning cycle on the oven, the door lock refused to open and an F1 code appeared on the display. Looking up this error code, I found that this normally indicates a bad touchpanel/circuit board. I purchased a new panel and repl;aced the old panel with this new one.

Low and behold the F1 code reappeared with the new panel installed. What other problem could cause the F1 fault to appear?

[PS Volunteer - Appguy]

Try replacing the oven sensor. Make sure you got all the wires in the right places; might want to check wiring with schematic.

[ArthurR6780]

My neighbor had a similar experience as the above; and it was finaly fixed by replacing the oven sensor