[SJGuy]

My old dryer just stopped heating. I just finished a load and it dried perfectly. I put another load in, started it, and heard a "pop". The dryer stopped. Then I hit the power button again and it tumbled and would not dry. Voltage at the outlet is reading correctly. And I've unplugged the machine and used my multi-meter set at RX1K on the three thermostats visible and get a reading of zero. Ideas?

[denman]

Here is a link to the parts
Kenmore Parts for Models 11076691100

Did you disconnect one wire from the thermostat when measuring, to ensure you are not actually reading an alternate path

Use 1X all should be 0 ohms

Check your heater, should be 8 to 15 ohms
Pop could be the element blowing