[mrfixitpd]

My dryer wont heat up. It runs and no heat. I replaced the igniter but that did nothing. What do I check next????

[PS Volunteer - JAXX]

we try not to assit in gas appliances please contact a gas certified tech for your safety

[alexk5]

If the replaced igniter glows but no gas is supplied to start heating cycle you may have a bad Flame Sensor. Try to tap on the flame sensor(located on the left side of the heat chamber) when the igniter is glowing. That should open the circuit to start gas flow. If that works you have a flaky flame sensor replace it. If that does not work, you can disconnect one of the wires on the Flame Sensor to manually open the circuit (be carefull, 110v). If that works then you may have bad coils on the valve assembly.

[eric shubert]

if they are so good then what are you doing over here. dosen't anybody use meters anymore when he removes the wire from the flame senor with 120 volts on it and lets say the dryer comes on WHAT are they going to do with the wire that is hot , start a lint fire???