[Rickl]

My dryer has become difficult! It starts up, burner kicks on (LP) runs for about 2 minutes and then shuts off. I have checked all of the lines to make sure there is no blockage (vent is clean to outside, internals are all clean). I have taken this apart and cleaned everything. I have replaced both coils (per my local Whirlpool service center). I'm wondering if it is the high temp sensor. Getting tired of just replacing parts piece meal. Any recomendations???? Can I check the thermostats to see if they are working properly????

Thanks,
Rick

[PS Staff - Sheila]

The function of the high temperature sensor is to cut the heat off if the dryer become to hot. I is unlikely that it is causing your problem.

You can check the thermostats two ways:

You can use a meter to see if there is continuity.

You can heat them and then let them cool and see if you hear a click.

The meter is the best way.

The problem could still be in the valve.

Here is a link to your dryer model LGR4634EQ1.