[Razzzhead]

When pressing reset, the LED flashes for a while, during which time the sequence should be reset (pump out, soap door open etc.), but nothing happens. Following this, the normal LED continues to flash with a beeping. If the reset is pressed again, the same thing happens all over.

I have looked through this forum and found the same symptom on another GE machine:- http://forums.partselect.com/dishwas...anel-4496.html. I followed the suggestion there and checked the sequencer switch, but it seems to be ok. When I reassembled the machine and pressed the reset, the sequencer switch cycled (I heard the sequencer motor run for a few seconds) but then the symptoms returned again - normal LED continue to flash etc.

I then checked the circuit board of the Control Switch Assembly (GE part #WD21X10100 PS260154) and noticed some areas of the circuit were slightly corroded. I cleaned the board with rubbing alcohol and it looked fine. But still no go - the same symptoms exist.

It seems to me that the Control Switch Assembly is faulty, but before I replace it I would like to attempt further troubleshooting. I didn't find a tech sheet in the machine, does anyone have one they could scan for me? Is there a circuit diagram and parts description available for the Control Switch Assembly? Any other suggestions?

[PS Staff - Sheila]

It does sound like the control has failed.

You may find the technician sheet stuck to the bottom of the tub or in the bottom panel.

Here is a link to your dishwasher model GSD4330Z02WW.