[dlmcilvain]

This dishwasher had a recall on the wiring harness and the kick plate was replaced with this recall and so went a "test sheet" that I hear was suppose to be there. Anyway, the dishwasher will not do anything. Resetting by cutting power does nothing. Pressing reset only ends up back to blinking normal and beeping. I am figuring at this point it is the sequence switch or the control module but is there a way to figure this out or am I off base.

[PS Staff - Sheila]

Check for loose wiring connection between the touch pad and control.

With out the technician sheet it will be hard to determine what is causing the problem.

Here is a link to your dishwasher model GSD5130D03WW.

[dlmcilvain]

Sheila, I checked all connections but it is still the same. After the recall was done, it did run for about 2 months just fine. I did take the sequence switch apart and set it back to start (all switches open) and still the same thing. The only thing that I could see that would be wrong in the sequence switch is the little electric motor. I have a power supply I made and could check to see that it runs.