 Motor swap Brand: General Electric Model Number: GSD 2800G01 Age: More than 10 years
I bought a replacement motor (WD 26X10013) for my dishwasher everything went smooth except the drain selenoid on my old model had four wires connected, one to a switch, the other to the selenoid.
The NEW selenoid only has two wires. What do you do with the orange and white/red wires not used that went to the old selenoid switch? Do you replace the new motor selenoid with the old one? I can't get the machine to run a complete cycle now , its runs until the first drain cycle then kicks off throwing code C3.
OH the white red/ grey are now going to the selenoid.
any help is appreciated! thanks..
Last edited by kaosv1 : 05-20-2008 at 09:05 PM.
| 
