[bk1golfer]

After my washer stopped working and I could not get any lights on the display to come on, I ordered a new control panel from the Parts Select website.

I then installed and powered it up. Started a wash cycle and got the error code "F1". I then cleared the error and started the wash cycle again with the same results.

I then shut it off for about 5 minutes and ran a self diagnostic check on the control board. The result was an "F80" error code.

Can you help me?

Thanks

[PS Staff - Sheila]

Can you please give the part number of the part that you replace?

Is this the Oasis washer?

Check and make sure the wiring connection are tight.