[jumpmaster2]

Selecting the NORMAL selector, the unit fills with water, washes and stops and adds a little more water. Wash cycle starts and works normal. At the end of the wash cycle unit will not empty. I called a service tech who came and said the Contro Board was bad. I bought a new Control Board and replaced the old one. Still have the same problem. Selecting the CANCEL button dose not empty the washer. Service Tech tested voltage to pump motor while in CANCEL and got a reading of 37.5 volts at pump motor. He said they must have sold me a bad board. Any help you can give me is greatly appreciated.

[paulettem]

I cant help but I have a similar problem my dishwahser is a whirlpool from Ikea and is nearly two years old. The water comes in but wont go out and starts to beep. There is also water continuously coming in from the water inlet valve of the water chamber on the left hand side. Is my dishwsher completely gone or is it a blockage? I removed the waste hose but the water is running freely through this.