[SMHughes]

After starting the dishwasher in the autoclean cycle it filled with water but then stopped. The display panel lights are on. I can push any of the cycles or the off/drain button, but nothing happens. It will not drain nor will any of the other cycles work. I would appreciate any help you can give me. Thanks!

[PS Staff - Sheila]

Try shutting the power to the dishwasher off at your breaker or fuse panel.

This may reset the electronic board.

If this does not work I would suspect the electronic board.

[tbottger]

Model: Jenn Air Series II
Model No.:JDB8910AWS

My dishwasher does the same thing. It fills up to start washing then pretty much shuts down. I heard a solenoid of some sort clicking and then shutting off. Took a closer look and it looks like it is coming from the circuit board (pcb's).

Do you suppose I need to replace the entire board, or can I replace a component that may be bad? Im very good with pcb's.

Thanks,

Tim

[tbottger]

i took out the pcb and found a broken solder on one of the pins. i resoldered the pin and put it back together and works like a charm.

I would check that out to see if one of your components looks as though a pin has broke free.

good luck

[Intense72]

Be careful when you do this because if you put the soder on the wrong part you'll really screw it up. I'd leave it up to a technician to do if for you. He'll probably just replace the board as it will get you your dishwasher running faster for you.
Note: And I shouldn't have to say this but make sure you have the unit unplugged and everything detached from the board if u decide to work on it yourself.