[josejr68]

The washer started flooding my floor yesterday. I shut it off then I ran it again today, it did not flood the floors but when it was done with the cycles, when I opened it the water was still collected at the bottom not draining. its about 3/4 of an inch deep just bellow the heat bar. Anyone run into this situation and know what to do? I bought the house new with dishwasher in December of 2003 so its 4 years and 5 months old. Thanks everyone

[PS Staff - Sheila]

The float may have got stuck and cause the dishwasher to over fill.

Remove the dome that is over the float and check to see if the float moves freely.

If you push the drain cancel button will the dishwasher drain?

Here is a link to your dishwasher model PDW7300J00CC.